- Minimum single run is 1 ft.
- Maximum single run is 18 ft.
- However, if the 150w driver is plugged into the 12V 4-Way Connector, you may add another 14 ft. on the opposite side of the original leg making the maximum run 32 ft.
Can be connected by wall plug or direct wire.
Polarity must be maintained. Each tape has positive pin. Connectors are marked with + symbol. Positive polarity must be maintained or a section will not light. It is recommended to install all sections and power up to make sure polarity is correct before adhering to surface.
Use the 12V 4-Way Connector and 2” sections to get 90º angles and turns.
The 12V 4-Way Connector can also be used to power branched runs up to the maximum. Positioning of the 12V driver is critical to limit the amount of drivers required for each installation. Position 12V driver in middle of, or corners of, runs and to power the 12V 4-Way Connector.
Connector Cords can be used between the driver and the first tape section, between sections, to go around corners and to extend runs.
Metal Channel can be used to install on irregular surfaces and also areas where tape will be visible and needs to be concealed.
12V Male End Cap and Silicone End Cap must be used at every termination whether tape is cut or not.
12V Dimming Controller will work on all 12V tapes except Aqua Star. 12V Dimming Controller is installed after the driver and before the first section of tape. There is a 140 watt capacity to this device.
|Listing:||, Eco-Friendly, LED, Energy Saving, Quick Ship, Mfr Specials, Energy Efficient, Title 24|
|Type of Cabinet Lights||Under Cabinet Strip & Tape Lights|
Bulbs are not eligible for replacement
People Who Viewed This Also Viewed
Write an online review and be the first to share your thoughts with other customers
Product Support History
Tag This Product
|Mfr Part #|
|Category||Under Cabinet Lighting - 90|
You currently have no recommended items. Browse a few more items to give us an idea of what you like.